Hypertherm Shield 220976 For PowerMax125 Plasma System Machine
We can offer you all plasma consumables for hyptertherm, Kjellberg,
Esab, Koike, Komatsu, Thermadyne, such as: electrode, nozzle,
shield, swirl ring, inner cap, retaining cap, water tube, torch
body and so on.
1. HEC Brand
We make metal cutting system and plasma cutter as well as torch and
consumables. We make plasma cutting machine and fiber laser cutting
machine with high quality and reliablity.
2. Cut Performance
HEC plasma consumables use high quality material and standard
process to make sure the highest quality. Our consumables cutting
performance is as the same as orginial OEM manufactory.
3. Good Price
HEC plasma consumables are good quality with low price make
customers best requirement and saving money.
4. Big Catagory
HEC sell all kinds of plasma consumables include Hypertherm, EASB,
Kjellberg, Koike and also supply some torch.
|Machine||HEC NO.||Ref NO.||Description|
|H71997||220997||Swirl Ring 45/65/125Amp|
|H71159||420159||Swirl Ring 45Amp FineCut|
|H11151||420151||Nozzle 45Amp FineCut|
|H11001||420001||Nozzle 30-125A gouging|
|H41977||220977||Retaining Cap 45/65/125Amp|
|H41156||420156||Retaining Cap 45/65/125A mechanized, ohmic|
|H21168||420168||Shield 45/65Amp mechanized|
|H21172||420172||Shield 45/65A drag-cutting|
|H21976||220976||Shield 125Amp mechanized|
|H21000||420000||Shield 125A drag-cutting|
|H21152||420152||Shield 45A FineCut|
|H21112||420112||Shieldg 30-125A gouging|
Plasma cutting technology
4, setting current
The current is set to 95% of the maximum current through the
nozzle. (the higher the current, the greater the hole of the
nozzle). The current is too low to produce "soft arc" and cold cut.
High current is consumed by nozzle.
5, select the appropriate plasma gas
If the system can use a variety of or two kinds of plasma gas,
according to the material and cutting thickness of the use of a
most suitable gas. (see gas selection table) and confirm whether
the gas pressure and flow are correct or not.
6, select the appropriate two gas
(see gas selection table) and confirm whether the pressure and flow
of gas / water are correct.
7 cutting torch and workpiece perpendicular to
If the cutting torch and the material is not vertical, will cut out
the angled slot. From the two aspects to check if the torch and
workpiece angle of 90 degrees.